Manitex 30124WL mounted on a Peterbilt 335 chassis with a Eaton Fuller 8LL.  The chassis has 74,541 miles and approx 11,000 hours. In the past 4 years - all new shims and wear pads, new wire rope, and annual inspections. In the past 2 years - new PTO (with throw bearing, clutch brake and fly-wheel was re-surfaced), new Clutch (heavy duty Eaton Fuller), new hydraulic pump, and wire rope. In the past 6 months Stephenson's equipment installed a brand new high-cast system and new main hoist cylinder (total bill was just over $20k). We are selling because we just bought a brand new 40ton crane. We used this crane daily up until our new crane arrived two weeks ago. The Anti-two-block is currently disconnected because we don't use it in the tree industry but the wire-line system is still in tact and recently tested and therefore we can reconnect for any prospective buyer upon request. The crane is used and has some imperfection (could use some TLC) but other than a small leak in the exhaust (have a new stack for it just never installed it) there are no known issues. Asking $95,000 OBO 

1998 Manlift Boom Truck, mobile crane, 50 ton lifting capacity, 123,000 miles